Standard Specifications

• Door boards and ledges and braces 21mm thick, giving an overall thickness of 42mm.
• Air nailed and glued
• Character grade oak 
• Unfinished
• Ledges 30mm shorter than width of the door
• Ledges and braces between 100mm-120mm
• Bottom ledge fitted 200mm from bottom of the door top ledge 80mm from start of the diagonal top
• Door boards V Groove
• Kiln dried Oak
• 2 horizontal ledges 
• Diagonal Top

Options Explained

1. Custom sizes are available, we make everything on site to order at our workshop in Lincolnshire so we specialise in bespoke sizes, any size is possible and there is no extra charge for this service. We just charge £11.99 (+ VAT)for every 100mm in width it is over standard size and any height over 2100mm is charged at an extra 5%. The measurements for the diagonal top will be to customer specifications so just let us know.
2. Diagonal braces are optional but are recommended as they improve strength and stability and stop the door from falling out of square, Cost for braces is £11.99 (+VAT) and would be sent without the angles pre-cut (2 pieces 1m long). 
3. Door as standard has 2 horizontal ledges, each additional ledge after this is charged at £5.83 (+VAT)which are 21mm thick and between 100mm - 120mm wide, this is decided by us at point of manufacture unless otherwise specified.  Ledges bigger than 120mm wide are charged at £20 (+VAT). All our ledges are manufactured 30mm shorter than the width of the door to be able to leave a 15mm gap either side for the door to close against the door stops. These can be made full width if required. All ledges are chamfered all the way round unless otherwise specified. All of these options are free of charge.
4. Door boards that are tongue and groove and slot together. These are 21mm thick and include a groove stile and a tongue stile to give you the finished edge. The boards have a V Groove applied but can square edged or Butt & Bead if preferred for no extra charge. Every door would not necessarily have 5 boards, this is determined at point of manufacture and is decided by us based on size of the door and timber available at the time (maximum board width 200mm) we can do a specific number of boards but it would need to be specified at point of order, again there is no extra charge for this service.
5. We offer 2 grades of oak - Character Grade and Prime Grade, the differences are briefly described below, please ask for our info sheet if you require more information.
   1. Prime- Minimal knots and colour variation - Tolerance on each face of two intergrown sound knots of 12mm maximum diameter, or this equivalent per linear metre. Slope of grain: almost straight. Not acceptable: sapwood, heart spiral and curly grain deterioration, cross grain, bark pocket, bore holes, warping. Surface checks tolerated. Extra £30 (+VAT)
   2. Character- Colour variation and knots -  Presence on each face of small knots without limitation, and of a maximum of three sound knots per metre, maximum diameter not to exceed one half of the width of the timber or 40mm or equivalent. No extra charge.
6. We do sell hand forged ironmongery packs that are ideal for use with these doors, these packs include 2 x Penny Tee Hinges 18" (a pair), 1 x Suffolk Latch set and are supplied with the necessary screws for fitting. £42.23 per set (+VAT)
7. Lock blocks are also available free of charge. 
8. As standard all doors come unfinished but we can apply an interior oiled or a lacquered coating if preferred for an extra £37.50 (+VAT) 
9. All our oak is kiln dried as standard which lowers the moisture content and kills off any woodworm or infestations. We can supply doors in green oak and air dried if preferred- please contact a member of our team for a price.