Standard Specifications

• Door boards 21mm thick
• Stiles and top and bottom rail 42mm thick
• Constructed with mortice and tenon joints
• Character grade oak 
• Unfinished
• Door boards V Groove
• Kiln dried Oak
• Overall door thickness 42mm
• Frame size 65 x 84mm, rebate size 42mm x 23mm, sill size 160 x 42mm 
• Frame is arched from the front but door is square and frame is square from the back.

Options Explained

1. Custom sizes are available, we make everything on site to order at our workshop in Lincolnshire so we specialise in bespoke sizes, any size is possible and there is no extra charge for this service. We just charge £11.99 (+ VAT) for every 100mm in width it is over standard size and any height over 2100mm is charged at an extra 5%. 
2. Door boards are tongue and groove and slot together. These are 21mm thick and include a groove stile and a tongue stile to give you the finished edge. The boards have a V Groove applied but can square edged or Butt & Bead if preferred for no extra charge. Number of boards per door is determined at point of manufacture and is decided by us based on size of the door and timber available at the time (maximum board width 200mm) we can do a specific number of boards but it would need to be specified at point of order, again there is no extra charge for this service.
3. We offer 2 grades of oak - Character Grade and Prime Grade, the differences are briefly described below, please ask for our info sheet if you require more information.
   1. Prime- Minimal knots and colour variation - Tolerance on each face of two intergrown sound knots of 12mm maximum diameter, or this equivalent per linear metre. Slope of grain: almost straight. Not acceptable: sapwood, heart spiral and curly grain deterioration, cross grain, bark pocket, bore holes, warping. Surface checks tolerated. Extra £100 (+VAT)
   2. Character- Colour variation and knots -  Presence on each face of small knots without limitation, and of a maximum of three sound knots per metre, maximum diameter not to exceed one half of the width of the timber or 40mm or equivalent. No extra charge.
4. As standard all doors and frames come unfinished but we can apply an exterior oil or lacquer for an extra £100 (+VAT) for door and £50 (+VAT) for frame  - this is a 2 coat system, a stain inhibitor base coat and then a UV protection top coat.
5. Weatherboard also available if being used externally which helps stop capillary action underneath the bottom of the door, this is an extra £23.33(+VAT).
6. It has always been considered good practice not to apply glue to the tongue and groove joints in the boards, this is to allow for natural expansion and contraction. Glue is just applied to fit the ledges and braces and these are then screwed and pelleted onto the boards   
7. All our oak is kiln dried as standard which lowers the moisture content and kills off any woodworm or infestations. We can supply doors in green oak and air dried if preferred- please contact a member of our team for a price.
8. Window can be any size required for no extra cost it just needs to be specified at point of order.